Transmitter AMU Powercon

In Steam and Water Cycle conductivity measurement is very basic, but the most important measurement. Specific conductivity (total conductivity), acidic conductivity, conductivity after cation exchanger CACE and degassed cation conductivity (DCASE) are measured at different location in steam and water cycle continuously Conductivity measurements give indication of contamination of water / steam with any kind of salts. These salts can get added to the water / steam from atmosphere or due to leakages in heat exchangers etc. The conductivity of ultra pure water is almost close to zero(say 1..2microsiemens/cm), while with addition of even 1ppm of any salt, the conductivity can shoot up to even more than 100 micro siemens/cm. Thus conductivity is a very good general purpose watch dog which can give a quick indication of plant malfunctioning or possible leakages. Typical points in the steam circuit where conductivity should be monitored are . Drum steam, Drum water, High pressure heaters, Low pressure heaters, Condenser, Plant effluent, D.M. plant, Make-up water to D.M. plant.

AMU Powercon Transmitter is single channel Panel mounted 4 wire conductivity transmitter from SWAN Switzerland. This Transmitter is available with Freely programable Analog Output as well as Relay Board and RS-485 Modbus or Profibus Option

Digitally Enabled